Engine Power Packages

289 / 315 Horsepower Carbureted Engine

 

  • Blueprinted machined 289  Block

  • Nodular Cast Iron Crankshaft, deburred and Micropolished

  • Hyperuetectic 9.5 to 1 Federal Mogul Pistons

  • Sealed Power Moly Rings

  • Heavy Duty Double Roller Dynagear Timing Set

  • Hydraulic Nostalgia Series Comp Cams Camshaft Power Range (2000 to 6000 RPM)

  • Federal Mogul Bearings

  • Aluminum 60cc cylinder heads with new valves, locks, retainers, seals and HD Springs

  • New Hardened Pushrods

  • Comp Cams Magnum 1.6 to 1 ratio Roller Rockers

  • Melling High Volume Oil pump

  • Complete Fel-pro Gasket set

  • Factory Replacement Harmonic Balancer

  • New Flexplate for Automatic Trans. (Standard Transmission Flywheel add $175.00)

  • Oil pan, Timing cover and Chrome Valve Covers

 

  • Edelbrock 650 cfm 4 barrel Carburetor with electric choke

  • Edelbrock Performer Dual Plane Intake Manifold

  • New high flow Water pump and Fuel Pump

  • High Energy Ignition Distributor Electronic with 53,000 voltage Coil Pak

  • New Spark plugs and 8mm Silicone Wires

  • New Thermostat Housing

  • Chrome Air Cleaner

  • PCV Ventilation System

  • New Fuel Lines and Gas Filter

  • Ignition Timing Set, Carburetor fully adjusted

  • Hot Run tested and dialed in

  • Video Footage taken with your engine running in our test Stand

  • Packaged and Crated

  • Installation Video Included

 

Total Cost $6,895.00

More Information      

Previous Page

1-800-704-5385

HOME PAGE


 

OPTIONS : New High Flow GTP Ford Cast Iron Heads

Polished Aluminum Billet March Pulleys, Brackets, V-Belt, 100 amp Chrome Alternator installed and adjusted  - $825.00  Serpentine Setup - $950.00