Engine Power Packages

351W / 310 Horsepower

Carbureted Engine with the complete
Turnkey Package


 
  • Blueprinted machined 351W version Block
    Nodular Cast Iron Crankshaft, deburred and
       micro polished
    Shot peened hardened connecting rods with
        190,000 psi bolts
    Hypereutectic 9.5 to 1 Federal Mogul Pistons
    Sealed Power Moly Rings
    Heavy Duty Double Roller Dynagear Timing Set
    Hydraulic Street performance Camshaft
      (Power Range 1500 to 5000 RPM)
    Federal Mogul Tri Metal Bearings
    Cast Iron 65cc cylinder heads with new valves,
       locks, retainers and seals
    New Hardened pushrods
  • Stamped Steel 1.6 to 1 ratio Rockers
       (Roller Tip is $130.00)
    New Melling  Oil pump
    Complete Fel-pro Gasket set
    Factory Replacement Harmonic Balancer
    New Flexplate for Automatic Trans.
    (SFI Approved Std. add $300)
  • New Oil pan, Timing cover and Valve Covers
    Installation Video Included
  • Edelbrock Performer Dual Plane Intake
    Edelbrock 750 cfm 4 barrel Carburetor
        with electric choke
    New Water pump and Fuel Pump
    Electronic Distributor with high voltage Coil
    New Spark plugs and 8mm Wires
    New Thermostat Housing
    Chrome Air Cleaner
  • PCV Ventilation System
    New Fuel Lines and Gas Filter
    Ignition Timing Set, Carburetor fully adjusted
    Hot Run tested and dialed in
    Video Footage taken with your engine
    running in our test Stand
    Packaged and Crated
 
 
 
 

Total Cost for all above components installed onto
the 351W / 310 Horsepower Engine $6,495.00


March Underdrive Billet Pulleys Installed with 100 amp Alternator & Bracketry with belts installed  - $825.00  Serpentine Setup - $950.00

 

Fuel Injected Version             More Information

Previous Page                  Home Page

1-800-704-5385