Blueprinted machined 351w version Block

Nodular Cast Iron Crankshaft, deburred
 and micro polished

Shot peened hardened connecting rods
 with 190,000 psi bolts

Hyperuetectic 9.7 to 1 Federal Mogul Pistons with Duralube Coating

Sealed Power Chrome Moly Rings

Heavy Duty Double Roller Dynagear Timing Set

Comp Cams Hydraulic Xtreme Energy Roller Camshaft

Sealed Power Tri-Metal Bearings

Aluminum fast burn  Edelbrock RPM cylinder heads with stainless steel valves, hardened valve locks, chrome
  moly retainers and HD Valve Springs

Chrome Moly  pushrods

1.6 to 1  Ratio Magnum Roller Rockers

New Melling Oil pump

Complete Fel-pro Gasket set

New Harmonic Balancer

New Flexplate for Automatic Trans.
 (Standard Flywheel add $300)

New Oil pan, Timing cover and Chrome Baffled Valve Covers

Edelbrock Victor Jr. Single Plane Intake with injector Bungs Installed

1000 cfm AVS Throttle Body It features all sealed ball bearings on the throttle shafts & progressive linkage. Comes complete with Ford idle control motor and throttle position sensor

Billet Aluminum Fuel Rails and Mounts

Ford Mass Air Computer

Complete Wiring Harness and all needed Sensors

Calibrated Mass Air Meter

Eight 30lb. injectors

New High Flow Water pump 

Electronic Mallory Ignition Distributor &  45,000 volt coil 

New Champion Spark plugs gapped and installed

 8mm Accel Silicone Wires

New Thermostat Housing

14 inch Chrome Air Cleaner

Base gasket, throttle cable bracket, assorted hardware and fittings necessary for the installation, PCV valve, instructions. Fuel Lines must be purchased separately.

Engine Spin Tested.

Packaged and Crated for Shipment