Cobra Kit Engine Buildup

  351W / 415 HP Engine

#7.

The Engine then Gets the Edelbrock 800cfm Thunder Series Carburetor, High Voltage Electronic Distributor, 8 mm Silicone Ignition Wires, Champion Spark plugs are gapped and Torqued into place. The Aluminum Elite Polished Valve Covers are installed with the Breather and PCV put in. The Low Profile / High Flow Air Cleaner is installed

#8.

The Entire March Serpentine Pulley Kit is Installed with a New 100 Amp. 1 Wire internal Regulated Alternator and New Sandon Polished Air Compressor. All the necessary bracketry is torqued to proper position and the Serpentine Belt is adjusted for proper Deflection. The Engine is Hot Run Tested for about an hour. All vital Readings are measured IE. Oil Pressure, Vacuum, Compression, Temperature. Distributor Timing is Adjusted along with the fine tuning of the Carburetor.

#9.

The Engine is Removed from our Test Stand. It gets Bolted to a Large Heavy Duty Pallet and Secured Tightley In place to avoid any problems in Transit.

# 10.

A Large Box is Put over the Engine after the engine is Stretch Wrapped in place. We ship Nationally and Internationally.

# 11

Shown here is a picture of one of our Engines Installed into a Recent Replica Car. Ready to Tear up some Asphalt !

Call us for Any of our Engine Combinations

Engine Factory

1-800-704-5385

Diagram # 7

Diagram #8

Diagram # 9

Diagram #11