Blueprinted machined 351w Block

Nodular Iron Crankshaft, deburred
 and micro polished

Shot peened hardened connecting rods
 with 190,000 psi bolts

Power Forged 10 to 1 Flat Top SRP Pistons

Sealed Power Chrome Moly Rings

Heavy Duty Double Roller Dynagear Timing Set

Comp Cams Hydraulic Camshaft (Power Range 2000-6500 RPMs)

Clevite Street Racing Bearings

Aluminum Fast Burn Edelbrock RPM Heads w/ Port matched intake Runners

2.02 x 1.60 Stainless steel Polished valves, Hardened valve locks chrome
  moly retainers and High Intensity Valve Springs

Chrome Moly Comp Cam pushrods

1.6 to 1 Comp Cams Magnum  Rockers

Melling Oil High Volume Oil pump

Complete Fel-pro Gasket set

New Heavy Duty Harmonic Balancer

New Flexplate for Automatic Trans.
 (Standard Flywheel add $300)

New Polished Oil pan, Alum. Timing cover & Polished Aluminum Baffled Valve Covers

Edelbrock AIR GAP Intake

Edelbrock 800 cfm  4 barrel Carburetor with electric choke

New High Flow Water pump 

New Electric Fuel Pump

Electronic Ignition Distributor &  high voltage coil with Vacuum advance

New Champion Spark plugs gapped and installed

 8mm Accel Silicone Wires

New Thermostat Housing

Chrome 14 inch Air Cleaner

PCV Ventilation System

New Fuel Lines and Gas Filter

New Serpentine Pulley Set with Sandon  Air Conditioning Compressor, New Power Steering Pump,100Amp CSI Alternator and the Underdrive March Performance Pulleys and Bracketry.

Ignition Timing Set, Carburetor fully adjusted

Hot Run tested and dialed In place

Video Footage with engine running in our test Stand

Packaged and Crated for Shipment